FABOOL Laser CO2(2019~) Manual
| No. | Parts Name | Notes | Pictures | Qty |
| 23 | Cable Carrier x-axis |  |
1 | |
| 24 | Cable Carrier y-axis |  |
2 | |
| 27 | Polyurethane Tube |  |
1 | |
| 77 | X-Motor Cable |  |
1 | |
| 78 | Y-Motor-L Cable |  |
1 | |
| 79 | Y-Motor-R Cable |  |
1 | |
| 95 | M2x8 Hex Socket Head Cap Screw |  |
4 | |
| pointer Cable |  |
1 |
Put the [27] Polyurethane Tube and [77] X-Motor Cable together with tape or something equivalent.
* If you have [Optional] pointer cables, put them together too.
Make sure that the cables are facing the right direction.
Put them through from the male part of the [23] Cable Carrier x-axis.
Put the [27] Polyurethane Tube and [77] X-Motor Cable (and [Optional] pointer cables if you have) together with [78] Y-Motor-L Cable with tape or something equivalent. Make sure that the [78] Y-Motor-L Cable is facing the right direction.
Put them through from the male part of the [24] Cable Carrier y-axis.
Attach the Cable Carriers in order of A through D.
Put about 380mm of the [27] Polyurethane Tube and [Optional] pointer cables out of the [23] Cable Carrier x-axis like in the picture.
Attach the connector of [77] X-Motor Cable on the x-axis of [33] Stepper Motor.
Attach the connector of [78] Y-Motor-L Cable on the y-axis-L of [33] Stepper Motor. Attach the switch of [78] Y-motor-L Cable on the [53] Limit Mount with 2 [95] M2x8 Hex Socket Head Cap Screws.
Put [79] Y-Motor-R Cable through from the male part of the [24] Cable Carrier y-axis.
Attach the [24] Cable Carrier y-axis in order of E through F. Make sure that the [79] Y-Motor-R Cable is facing the right direction.
Attach the connector of [79] Y-Motor-R Cable on the y-axis-R [33] Stepper Motor. Attach the switch of [79] Y-Motor-R Cable on the [53] Limit Mount with 2 [95] M2x8 Hex Socket Head Cap Screws.
