FABOOL Laser CO2(2019~) Manual
| No. | Parts Name | Notes | Pictures | Qty |
| 61 | Flow Sensor |  |
1 | |
| 72 | RELAY DC POWER Cable |  |
1 | |
| 73 | RELAY MOTOR Cable |  |
1 | |
| 74 | RELAY SIGNAL Cable |  |
1 | |
| 76 | Laser Cable |  |
1 | |
| 75 | FAN Cable |  |
1 | |
| 38 | Cable Ties |  |
5 | |
| 89 | M3 Post-Assembly Nut |  |
1 | |
| 100 | M3x12 Hex Socket Head Cap Screw |  |
1 |
Attach the [76] Laser Cable to the [18] Power For Laser.
Attach the [75] FAN Cable to the [25] Water Cooling Pump and the [21] LED DC Fan. Make sure the Black-White cable is connected to the [25] Water Cooler Pump, and the Red-Green cable to the [21] LED DC Fan.
Fix the following cables with the [38] Cable Ties to the attached [39] Cable Catches as follows.
– Left side –
• [81] Y1-Limit Cable
• [79] Y-Motor-R Cable
• [80] Switch Cable
• [75] FAN Cable
– Right side –
• [81] Y1-Limit Cable
• [79] Y-Motor-R Cable
• [80] Switch Cable
• [75] FAN Cable
• [76] Laser Cable
Fix the following cables with the [38] Cable Ties to the attached [39] Cable Catches as follows.
• [81] Y1-Limit Cable
• [79] Y-Motor-R Cable
• [80] Switch Cable
• [75] FAN Cable
• [76] Laser Cable
Pass the [76] Laser Cable magnet switch circled in red in the photo from the back left side of the main body through the front left side.
Mount the magnet switch to the inside of the [6] 800mm Aluminum Frame 20*20mm with a [89] M3 Post-Assembly Nut and [100] M3x12 Hex Socket Head Cap Screw.
Use the pictures as references for the wiring.
* For those who purchased the optional “”FABOOL Laser CO2 Positioning Kit””
