FABOOL Laser DS (2018/08~) Manual
| No. | Parts Name | Notes | Pictures | Qty |
| 121 122 |
Height Adjustment Jig |  |
1 |
Put [17]Wheel Plate x-axis aside to the left.
As well as the move to the left, adjust the position of Limit Mount from the center of the mirror to the position separated slightly from the Limit, so as to make 1050mm long space to the right to move it.
Put [16]Wheel Plate y-axis aside to the left.
As well as the move to the left, adjust the position of Limit Mount from the center of the mirror to the position separated slightly from the Limit, so as to make 630mm long space to the right to move it.
Place the article for processing on the processing bed.
Assemble [121]Height Adjustment Jig 1 and [122]Height Adjustment Jig 2 as it shown in the picture.
Place [19]Lens Mount on the article for processing. The focus is set on the surface of the article in this position. After the adjustment, make sure to tighten the thumbscrew.
Remove [121]Height Adjustment Jig 1 and [122]Height Adjustment Jig 2. Head height adjustment is now completed.
