FABOOL Laser DS (2018/08~) Manual
| No. | Parts Name | Notes | Pictures | Qty |
| 98 | Relay PCB | Installed Utility BKT2 |  |
1 |
| 86 | Water Cooling Pump | Installed Utility BKT2 |  |
1 |
| 88 | Radiator Unit |  |
1 | |
| 84 | Power For Laser | Installed Utility BKT1 |  |
1 |
| 87 | Tank |  |
1 | |
| 196 | Tank Holder |  |
1 | |
| 145 | M5x8 Low Head Screw |  |
8 | |
| 139 | M5 Post-in Nut |  |
8 | |
| 133 | M4x6 Hex Socket Head Cap Screw |  |
4 | |
| 135 | M4x10 Hex Socket Head Cap Screw |  |
2 | |
| 162 | M4 Post-Assembly |  |
2 |
*Requiring Attention in Installation
Attach [98]Relay PCB assembled in “Relay PCB/ Power For Laser assembly” section on the main body frame with 2 of [145]M5×8 Low Head Screw and 2 of [139]M5 Post-in Nut.
Attach [88]Radiator Unit on Bottom-BL with 4 of [133]M4×6 Hex Socket Head Cap Screw referring to the picture.
Attach [86]Water Cooling Pump assembled in “Water Cooling Device Assembly” section on the main body frame with 2 of [145]M5×8 Low Head Screw and 2 of [139]M5 Post-in Nut.
Attach [196]Tank Holder on the frame with 2 of [135]Hex Socket Head Cap Screw and 2 of [162]Post-in Nut.
Attach [87]Tank in the [196]Tank Holder. *There’s a possibility of the tank being damaged if you tighten too much.
Attach 80W laser assembled in “Relay PCB/ Power For Laser assembly” section on the main body frame with 2 of [145]M5×8 Low Head Screw and 2 of [139]M5 Post-in Nut.
Attach [84]Power For 80W Laser approximately 180mm away from the interior wall part of the main body frame referring to the picture.
