FABOOL Laser Mini (2017/08~) Manual
| Part Name | Part ID | Qty |
|---|---|---|
| Stepping Motor | D-5 | 3 |
| motor mount plate x-axis | C-1 | 1 |
| motor mount plate y-axis | C-1 | 2 |
| Timing Pulley | C-3 | 3 |
| M3×6 Hexagon socket head cap bolt | C-1 Screw case | 12 |
※(for shipments later than Aug 23rd 2018) Set screw is included in the screw case for all countries except US
※See FABOOL Laser Mini packing list for parts ID.
[Caution] DO NOT turn the switch on until assembly is completed.
Install motor mount plate x-axis on stepping motor with M3×6 Hexagon socket head cap bolt.
*For the direction of motor mount plate x-axis, make sure that the two small holes are on the bottom right.
Insert timing pulley in the spindle of stepping motor, then tighten the 2 set screws with hexagon wrench.
*Make sure that the timing pulley’s orientation is correct.
*Set screws are inserted in the timing pulley from the beginning.
※(for shipments later than Aug 23rd 2018) Set screw is included in the screw case for all countries except US
If the timing pulley cannot be inserted smoothly, loosen the 2 set-screws with the hex wrench and try inserting again.
*Use caution as the set screws come off easily when they are loosened too far.
Insert the timing pulley fully into the spindle. (Position adjustment will be done later so exact alignment is not necessary at this point.)
Assembly of X-axis motor unit is complete.
As shown in the picture, install the motor mount plate y-axis into the stepping motor using M3×6 hex screw socket bolt.
*Refer to the picture to make sure that the position of the holes in the motor mount plate y-axis are symmetrical.
As with the x-axis, insert the timing pulley into the spindle of the stepping motor and tighten the screws.
Make sure to insert the timing pulley fully into the spindle. (Position adjustment will be done later so exact alignment is not needed at this point.)
Assemble the other one following the same procedure, making sure that the orientation of the motor mount plate y-axis is correct.
Assembly of y-axis motor unit is complete.