Smart Laser Mini Manual
| Parts | Detail | Qty |
|---|---|---|
| X-Lmit | Harness | 1 |
| Y-Lmit | Wire Harness | 1 |
| M2.5×14 hexagon socket head cap screw | stainless steel | 2 |
| M2.5 nuts | stainless steel | 2 |
Position to mount a limit is the part that is enclosed in red.
Please mount it according to the direction like this picture.
Please fix using the Hex Key and spanner.
Please adjust the location of the motor unit to the position where the limit can be attached to the mini v plate y-axis (acrylic) by moving the X-axis unit.
In some cases, mini v wheel results in attaching to the instrument such as a bracket. Please adjust it by moving the motor unit in that case.
Please fix the motor unit completely after adjustment. On the opposite side, please mount the limit in the same position.
Stretch the timing belt.
And stretched the timing belt while holding down the Y-axis idler unit in the direction of the arrow to fix the idler unit.
On the opposite side, please insert the timing belt in the same way.
Position to mount a limit is the part that is enclosed in red.
Please mount it according to the direction like this picture. And fix using the Hex Key and spanner.
Please make sure that the limit can attach to the mini v plate X-axis (acrylic) by moving the mini v plate X-axis unit. Please adjust the location of the motor unit if it can not attach.
When adjusting the position of the motor unit, please watch out that the timing pulley and the body do not touch each other.Please adjust the position of the motor unit and idler unit if they touch each other.
Stretch the timing belt.
And stretched the timing belt while holding down the X-axis idler unit in the direction of the arrow to fix the idler unit.
Then the drive part is completed. Please make sure that X-axis and Y-axis are perpendicular. (Check if it is tilted or not)
