Smart Laser CO2 Manual
Please attach the #2 reflection mirror to mirror mount.
Irradiate to the #3 reflection mirror.
Start from the near position like when irradiating the #2 mirror.
Irradiate right before to the X-axis.
If it’s substantially angled horizontally, get the angle smaller by tilting the mirror mount itself.
If it’s angled a lot vertically, angle the aluminum frame that is fixing the second mirror mount to get the angle smaller.
Fix the position with the angle of the mirror mount and aluminum frame.
Adjust it slightly with an adjusting screw of the mirror mount.
Fix the angle a little for both close distances and far away distances.
Please attach the #3 reflection mirror when it’s not tilting vertilcally.
Irradiate to the laser head point.
If it’s far away, please fix the #3 reflection mirror’s mirror mount.
Please adjust to be irradiated in the transverse direction to the center.
For slip of the top and under side, please move up and down with the mirror mount and adjust it.
For a slip of the Y axis way of the second reflection mirror, move the mirror mount of the second reflection mirror itself vertically to adjust the position.
Please make sure that is irradiated to the center of the #3 reflection mirror.
Irradiate to the laser head part and adjust it slightly with an adjusting screw of the mirror mount so that the laser is at the center.
Please irradiate with a laser in 4 corners of the processing area, please check whether it is irradiated to the center.
Attach the condenser lens.
The condenser lens has a specific aspect, so put it on carefully. The side that is puffed up is the top.
