Frame Set for Expansion Manual
First, cut the cable tie to remove the timing belts on x-axis and y-axis.
Next, open the PCB case and cut the cable tie holding the cables.
Detach that cables attached to the boards, as well as from the right side of PCB case.
(You do not need to remove the fan from PCB case.)
Detach laser board and control board.
Next, detach cables from the machine.
Only the two cables shown below are necessary.
(Keep the other cables.)
Detach all units from the frame body and disassemble the frame.
You will need the parts shown below as well as the screws/nuts removed in the process above.
Detach all wheels from mini v plate_R and mini v plate_L on normal FABOOL Laser Mini.
(These will be installed on the mini v plate for 1.0m Expansion Kit later in the process.)
Use hex wrench and a spanner.
Detach all.
