FABOOL Laser CO2 Manual
| Parts | Qty | |
|---|---|---|
| Laser tube | 1 | |
| tube mount | 2 | |
| Laser tube mount | 2 | |
| M10 washer | 2 | |
| M10×10 hex socket head cap bolt | 2 | |
| M5×8 hex socket head cap bolt | 4 | |
| M5 last-in nut | 4 |
Unscrew both in the upper and bottom sides of Laser tube mount.
Screw in order of the picture below.
The order is Laser tube mount→tube mount→M10 washer→M10x10 hex socket head cap bolt.
Screw another one in the same way as the previous one.
Set the tube mount which has been screwed on laser tube support (under) with M5×8 hex socket head cap bolts.
Here is an example of setting about the side of water cooling pump.
Here is an example of setting about the side of control board.
Put laser tube on laser tube support (under).
Then, fix it with laser tube support (upper) and the screws that unscrewed from laser tube mount at the first part in this section.
Fix the other side likewise.
Please check laser tube whether it is fixed firmly. If it move very easily, please tighten it.
※Don’t screw very tightly. There is a possibility of breaking laser tube as it is glass.