FABOOL Laser Mini Manual
| Part Name | Part ID | Qty |
|---|---|---|
| PCB case | D-1 | 1 |
| Laser Board（1.6W/3.5W） | A-1 | 1 |
| Control Board | A-1 | 1 |
| M5×6 low head bolt | C-1 screw case #(4) | 2 |
| M3×4 hex socket head cap bolt | C-1 screw case #(8) | 9 |
| Washer | D-1 | 8 |
| Cable tie catch | C-1 | 1 |
*1. Products shipped after the end of September 2016 include M3x5 hex socket head cap bolt instead of M3x4 hex socket head cap bolt.
*2. Products shipped after the end of September 2016 do not require washers.
*For parts ID, see FABOOL Laser Mini packing list
*For the instruction of 3.5W model, click here.
See the picture below for the orientation and position of laser board.
Insert washer between spacer, which is already attached to the PCB case and the laser board, then tighten with M3×4 hex socket head cap bolt (four points).
*Products delivered after September 2016 include different types of screws, and do not require washers. Disregard the picture below and attach the laser board to spacer on PCB case using M3x5 hex socket head cap bolt (4 points).
Place the PCB case on V-slot 410mm on the back of body. Fix it using two of the M5 t nut and two of the M5×6 low head bolt (already inserted while assembling the frame). Aim for the center for the mounting position.
Insert a washer between the control board and M3×4 hex socket head bolt and tighten it (four points).
*Products delivered after September 2016 include different types of screws, and do not require washers. Disregard the picture below and attach the laser board to spacer on PCB case using M3x5 hex socket head cap bolt (4 points).
To install the DC fan, tilt by 5mm two heat sinks on the laser board. (See picture.) If you tilt it too much it will hit the side cover. Make sure it does not touch the side cover.
The 5mm is from the state where the board and heatsink are horizontal.
Behind the red circle (see picture), fix the cable tie catch with hex socket head cap bolt. See the picture for the orientation of the catch.
*If you are using 1.6W model, skip this part.
See the picture below for the orientation and position of the laser board.
Insert washer in between spacer, which is already attached on PCB case, and the laser board, then tighten with M3×4 hex socket head cap bolt (four points).
*Products delivered after September 2016 include different types of screws, and do not require washers. Disregard the picture below and attach the laser board to spacer on PCB case using M3x5 hex socket head cap bolt (4 points).
Place the PCB case on V-slot 410mm on the back of body. Fix it using two of the M5×6 low head bolts (already inserted while assembling the frame). Aim for the center for the mounting position.
Insert a washer in between the control board and M3×4 hex socket head bolt and tighten it (four points).
*Products delivered after September 2016 include different types of screws, and do not require washers. Disregard the picture below and attach the laser board to spacer on PCB case using M3x5 hex socket head cap bolt (4 points).
Behind the red circle (see picture), fix the cable tie catch with hex socket head cap bolt. See the picture for the orientation of the catch.
