Smart Laser CO2 Manual
| Parts | Detail | Qty |
|---|---|---|
| Laser pointer board | PCB | 1 |
| Button battery | CR2032 | 1 |
| M5 T-nuts | Stainless steel | 2 |
| M5×6 Hexagon socket countersunk bolt | stainless steel | 2 |
Attach M5-T nuts and M5×6 Hexagon socket countersunk bolt to Laser pointer board in advance.
Attach to the X-axis unit.
Attach the Button battery.
| Parts | Detail | Qty |
|---|---|---|
| laser pointer holder | aluminum | 1 |
| laser Pointer | dot or line | 1 |
| M3×8 Hexagon socket countersunk bolt | stainless steel | 1 |
| M3 washer | stainless steel | 1 |
| M3 Set screw | — | 2 |
Insert set screw to the laser pointer holder.
Attach laser pointer holder to the laser nozzle using M3×8 Hexagon socket countersunk bolt and M3 washer.
Attach the laser pointer then connect the LaserPointer board to connector.
Place working material on the working bed, then adjust height of the laser nozzle.
Irradiate with a laser and adjust the position.Take the cover top back out.
Please use”irradiating button“Or” Optical axis adjustment button“Please wear CO2 laser Protective goggles to protect your eyes.
Irradiate a laser. Avoid to irradiate a laser for a long time.You can be one press on the button,the laser will be irradiated stronger.
Please match the position of the laser light of the laser pointer to an actual irradiation point.Then turn the switch on.
Adjust the laser pointer holder position and slant of the laser pointer.
It is completion of adjustment.
If you use the optical axis adjustment button, please take it out and attach the cover top back.When you positioning on working material, please turn it on.
