Smart Laser Mini Manual
| Parts | Detail | Qty |
|---|---|---|
| Power | laser board power cable | 1 |
| Signal | Laser signal cable | 1 |
Connect “Power” cable to the position of the controller and laser board that is enclosed by a red.
Connect “singal” cable to the position of the controller and laser board that is enclosed by a red.
| Parts | Detail | Qty |
|---|---|---|
| X-Motor | X-axis motor cable | 1 |
| Spiral tube | — | 1 |
| Cable tie | — | 3 |
Mount the “X-Motor” cable to the X-axis motor.
Tie the “X-Motor” cable and “X-Lmit” cable with cable ties, and wrap the spiral tube.
Pass through the cable ties in two holes of the “motor mount plate x-axis (acrylic)”, and then fix the cable.
Please cut the remainder of the cable ties with such as nippers.
Connect the “X-Motor” cable and “X-Lmit” cable to the place surrounded by a red.
| Parts | Detail | Qty |
|---|---|---|
| Y-Motor-L | Left side Y-axis motor cable | 1 |
| Y-Motor-R | Right side Y-axis motor cable | 1 |
| Cable tie | — | 2 |
Please connect the “Y-Motor-R” cable to the right Y-axis motor.
Please connect the “Y-Motor-L” cable to the left Y-axis motor.
Fix the “Y-Motor-R” cable with cable ties.
Fix the “Y-Motor-L” cable, “Y-Limit” cable, “X-Motor” cable, “X-Limit” cable with cable ties.
Connect the “Y-Motor-R” cable, “Y-Motor-L” cable and “Y-Lmit” cable to the place that is enclosed in a red.
| Parts | Detail | Qty |
|---|---|---|
| Laser-OUT/Laser-FAN | Laser module cable | 1 |
| Corrugate tube | — | 1 |
| Cable tie | — | 2 |
Wrap corrugate tube to the”Laser-OUT / Laser-FAN” cable.
Wrap corrugate tube to the”Laser-OUT / Laser-FAN” cable.
Please pass though the cable ties in the two holes of mini v plate x-axis unit, and then fix the corrugate tube.
Pass though a cable tie in the hole of pcb mount and fix the opposite side of the corrugate tube.
Connect the “Laser-OUT” cable to the place surrounded by a red.
The laser will be damaged if the “Laser-OUT” cable is connected to other places by mistakes. please do not connect to except for the following points.
Connect the “Laser-FAN” cable to the place surrounded by a red.
| Parts | Detail | Qty |
|---|---|---|
| AC adapter | Power supply for controller | 1 |
| USB cable | ArduinoMEGA・PC | 1 |
Connect the plug of the AC adapter to the place surrounded by a red.
Please be careful that do not connect to the DC jack of Arduino MEGA.
Connect the B type side of the USB cable to the USB port of the Arduino MEGA, and then please connect the A type side on the opposite side to PC.
